Engine to transmission bolts/nuts sizes?

[eaton]

I'm getting ready, finally, to install a 1970 T engine in my '66. The engine has two studs at the bottom for nuts on the transmission side, and two threaded holes to accept bolts at the top. I only have one bolt, the one that doubles to attach the starter. I can't find the two nuts I need, or the other bolt, in any catalog or parts site. Does anyone know the specs? I'm thinking I could get them from the hardware store? Also, washers on all four? Loctite?


Thanks, Joe

[jrbennett]

I'm sure the nuts and bolts are 10mm thread. I believe the nuts have a 15mm outer/wrench size and normal 10mm nuts usually use a 17mm wrench.
I have this part number listed for the nuts, 900-157-002-03 and N-012-242-3 for the spring washer under the nuts.
As for the bolts, I'll look and see if I have a length listed.

[jrbennett]

I just found the numbers in an old parts list.

Long bolt through starter M10 x 110,
900-067-074-02

Spring washer for starter bolt
901-604-581-00

Short bolt M10 x 72
900-155-023-02

M10 washer (x3)
900-031-005-02

M10 lock washer (x3)
999-523-103-01

M10 nut (x3)
900-157-002-02

[Richy]

For a '66 the nuts should be 17mm atf with a wavey washer : for a '70 they are 15mm atf with a small od flat washer and a schnor washer .

[eaton]

Thanks guys. People on this site are great.