Rubber seal/gasket checklist

[Jrsully]

Hoping somebody may have put this together during a previous resto. Have a 71 Targa and I'm getting ready to do a complete glass out resto and was looking for a "checklist' of all the rubber seals/gaskets etc that should be replaced. Have the obvious F/R windshield and Targa Top stuff, wondering about the small ones I'll need to replace. The car was missing a bunch so I'm in the dark a bit. Any help appreciated

[classic]

1. Bumper trim profile, including end caps profile.
2. Overrider trim profile
3. Front bumper trim seal
4. Fender to light seal and light drains
5. Bonnet seal and badge seal
6. Wiper seals
7. Windshield and rear window/ Targa seals
8. Fender to scuttle trim profile
9. Durrant base seal
10. Door handle
11. 1/4 window profile
12. Window felt
13. Window squeegee
14. Window fuzzy
15. Door bolt plugs
16. Door seal
17. T bar cover seal
18. Rear bumper seals
19. Bumper end cap profile
20. Rear Overrider profile
21. Rear licence panel concertina seal
21. Rear licence panel seal
22. Indicator seals and drains
23. Licence plate light seals

Pretty sure that covers it, but I haven't done a Targa so I may have forgotten a couple of specific seals.

[Jrsully]

Thanks very much Tony, big help.

[Silverbullit]

Also, Try viewing a vendor's catalog (International Marcantile) for good exploded diagrams with descriptions

[Eminence Gris]

Very good list. There is also a seal between the outer door top trim and the vent window (figure 8 profile)

[RSTarga]

window stop at top of 1/4 window
Targa bar plugs
Rubber covers for interior light switch in door frame

[Fishcop]

Engine bay skirt (2 parts) that seals to the engine tin. There are also a couple of rubber seals in the air box/snorkel interface.