CV joint replacements for 1969 911T

The CV joints on my 1969 911T are worn out. I would like to replace the whole axle shaft as that seems to be the easier and cheaper option (plus I’m on a time crunch now).

When I look at the replacement units from GKN Loebro part number 911 332 033 09
they have a six bolt pattern while my originals have a four bolt? This would leak / splatter CV grease everywhere.

Any solutions?

Cheers

-Kav


http://forums.pelicanparts.com/uploa...1534261010.jpg

http://forums.pelicanparts.com/uploa...1534261230.jpg

Two of the 'holes' are not drilled all the way through in the replacements (or in the case of the above photo have roll pins installed), so you should be fine.

Thanks!

Looks like there are couple of part numbers listed. My originals are 4 bolt, diam 108, width 30, length 475 , spline 30 but no one gives specifics on their part number.

911-332-033-09-M60

901-332-026-11-M60

Any advise?

Cheers

-Kav

Kav - I am more familiar with what I've used in restoring a 70, 72 and 73 911...all used the same axles. You might find that of the two numbers you have noted above, they supersede to as single number...a call to your PORSCHE dealer parts guy should be able to answer that. I regularly provide my guy with numbers listed in the original maroon parts books..many are the same, but just as many have 'new' numbers.