Attachment 515872
“Wash” and drive
Printable View
Attachment 515872
“Wash” and drive
I've been continuing to plug away on the interior. It's been slow going due to the fact that my upholstery guy is backed up quite a bit with another project, so I've been doing a lot of it myself. The carpet kit that was in the car seemed to be home made, and did not prove to be the greatest pattern for the new square weave. I'm also still learning how to sew the binding etc. Overall, it's turning out pretty good. Not to the quality that I was shooting for, but it is going to be a driver. I still need to tweak some fitting and details though.
The rear seat delete storage box will be removable, if I choose to re-install the seats.
Sorry about the poor cell phone pictures.
Beautiful work and use of materials, elegant
I've also been making some custom kick panels. I started with cardboard templates, then used ABS sheet and bent them using a heat gun. They will be covered with carpet once I get them in and fitting properly. I think they will look pretty clean once they are finished, and the pedal boards are in.
I am also planning to cover the heater hoses in matching vinyl, or replace them with new clean ones.
Attachment 517755
Attachment 517756
Attachment 517757
Attachment 517758
Attachment 517759
Attachment 517760
Bob --- Nicely done! I like the attention to detail.
David
…..got photos of the freshly tumbled box before assembly....something about these aluminum boxes......now for the new sideplate, fresh LS, and onward
Attachment 518083
Still plugged away on the interior. The floor mats still need backing and binding sewn on, and the seats need to be re-shaped and upholstered.
Attachment 518719
Attachment 518720
Attachment 518721
Attachment 518722
I fired up the lathe to make some Solex accelerator pump adjustment screws as for some unexplainable reason three of mine went missing. Ready to go out for plating on monday
Attachment 519702Attachment 519703