Car Looks great Gibb - you must be itching to be driving it! I've been travelling through Arizona & New Mexico today heading for Colorado. If I had more time I would have tried to arrange to swing by your way for a look at your stable
Cheers, Cam
Car Looks great Gibb - you must be itching to be driving it! I've been travelling through Arizona & New Mexico today heading for Colorado. If I had more time I would have tried to arrange to swing by your way for a look at your stable
Cheers, Cam
Looking for engine # 6208151
'74 RS 3.0 Replica
'70 911E Bahia Red (SOLD)
'71 911 S/T Replica 2.3 Twin plug BEAST (SOLD)
Australian TYP 901 Register #78
Early S Registry # 1076
Thanks, Cam...hope your drive to Colorado was a safe one. Some of the most beautiful country in the world in that state.
Starting to hook up things underneath. There is an issue with the speedo drive boss that I will need to address, so will hold off mounting the rear sway bar for now.
Edit; The headers are 1 5/8 European-by-George type, powder coated Titanium.
Last edited by letsrollbabe; 08-07-2017 at 02:55 PM.
Gib Bosworth
EarlySReg 434
R Gruppe 17
I had to pull the engine out of the car today...bummer. The mechanical speedo threaded bung on the tranny nose cover needed repairing, and I couldn't do it in the tiny space under the car. I think I have it successfully repaired now, and will put the engine back in tomorrow. Meanwhile...it's a dance with red and yellow 911s swapping places back and forth.
Gib Bosworth
EarlySReg 434
R Gruppe 17
Finally got around to replacing the black HL surrounds on the chrome H4s with black H4 rings...they fit much better and look more refined. Adjusted the hood and removed the hood shocks which caused the FG hood to bulge in the middle and not lie flat. Interior is next.
Gib Bosworth
EarlySReg 434
R Gruppe 17
Bert Jayasekera
1970 911T - Tangerine Orange
Early 911S Registry #494
R Gruppe #167
Car is looking great!
keith
'75 RS/RSR-look | '73 CB750 | '70 TD250B
r gruppe # 436
Bert,
Headers with extensions always take a little finesse to get fitted...but it's not too hard. It is a good idea to not tighten bolts until it is all assembled. The 1 5/8" is OD.
The ride height looks higher now... it is because I had it on the lift again and didn't roll it around much to let it settle down. The rubber bushings take some dynamics to reach a final resting spot...
Thanks for the comment, Keith.
Edit: For those who asked privately...the Light yellow ST is sitting high in the rear because its engine is out being rebuilt into a twin plug 10.3 CR 2.7L.
Last edited by letsrollbabe; 08-14-2017 at 05:25 AM.
Gib Bosworth
EarlySReg 434
R Gruppe 17
Ordered the RS carpet and door panel sets today, will begin installing them next week. My fix for the speedo bung didn't work, so I have ordered another nose piece. Fun working on 40 year old cars...
Gib Bosworth
EarlySReg 434
R Gruppe 17
We had a big thunder storm early this morning...lightening and wind too, but not much rain. It made for some good light to take some pics. Within 15 minutes after taking these the skies cut loose again with more rain. In the desert, we celebrate rain, often standing inside just watching it come down. We only get maybe a dozen of these days per year in most years....
Gib Bosworth
EarlySReg 434
R Gruppe 17
Well...it's no Singer...not even close, but for the poor-of-wallet it will satisfy the urge pretty well when it finally gets running.
Gib Bosworth
EarlySReg 434
R Gruppe 17