Nice Tom. Are those flat washers or spring washers on the seat rails.? Doing the same job myself tomorrow.
Dave
Nice Tom. Are those flat washers or spring washers on the seat rails.? Doing the same job myself tomorrow.
Dave
https://www.facebook.com/Beltwerks-139610016684496/
S Registry # 1660
Le Belgique ST build.
http://www.ddk-online.com/phpBB2/vie...p?f=28&t=42628
Dave
I used flat washers. The low mileage '70S photos, as well as other photos I looked at, seemed to shown flat washers. The PET however spells out a lock ring.
Tom Butler
1973 RSR Clone
1970 911E
914-6 GT Clone in Progress
Good homework Tom. Flat washers it is then.
Dave
https://www.facebook.com/Beltwerks-139610016684496/
S Registry # 1660
Le Belgique ST build.
http://www.ddk-online.com/phpBB2/vie...p?f=28&t=42628
There's a close tolerance small OD lock washer that is hard to see in the picture . They are used on all the allen head bolts . I've gotten them from McMaster Carr .
My '70 Targa project also had small lock washers under every allen head bolt. Based on the rust and other crud on the bolts, I don't think they had been previously removed, but can't confirm it's original.
Last edited by denniso; 08-17-2019 at 09:31 AM.
Got it. Thanks for the tip.
Tom Butler
1973 RSR Clone
1970 911E
914-6 GT Clone in Progress
Tom
Missed your 8/14 post till this morning ....mounting of front bumper, trim housings etc.
Fantastic fit. Great work.
Also having similar issues with the rears, am still mounting the donated rear 1/4 panels , bumpers ,guards and light housing.
I am mocking up all details before welding the 1/4 panels as there is some minor adjustment I can do at this stage.
DS seems to be dialing in just fine but PS bumper is more challenging.
Keep up the great work !
Frank
73.5 Snrf T
71 Snrf T
70S targa
76 914 2.0
82 Targa,
85 Alfa GTV6
60 Lancia Appia Zagato GTE
Searching for transmission 7115322 (911/01)
Tom
Am sure you worked them but I had good luck with the fit and the rubber trim by adjusting tension on the Rear of bumper and J tube bolted connection ....as well as the clamp type between the fender edge and the bumper as they clamp together via the bolt connection.
That is a very tricky detail to get right .
Good luck and keep us posted
Frank
73.5 Snrf T
71 Snrf T
70S targa
76 914 2.0
82 Targa,
85 Alfa GTV6
60 Lancia Appia Zagato GTE
Searching for transmission 7115322 (911/01)
Thanks for the tip Frank. I was able to fit the L&R bumpers to my satisfaction but then the brackets for the bumper guards would not fit the license plate panel. I went round and round adjusting the brackets and fitting the license panel and bumper guards. In the end I decided to move on and let the pros do the final adjustments.
Tom Butler
1973 RSR Clone
1970 911E
914-6 GT Clone in Progress