300096

[NeunElf]

This seems to be a reproduction of the 64-key pouch.
https://www.ebay.de/itm/Original-POR...0AAOSw5nJc9ptm

Bernd

Funny, those key fobs are 15,70 € cheaper at Erlkönig Classic's website. It's unlikely these particular key fobs with Karosserie Reutter stamped on one side would have been given out after Porsche bought the Reutter factory in 1963.

[718RSK]

Funny, those key fobs are 15,70 € cheaper at Erlkönig Classic's website. It's unlikely these particular key fobs with Karosserie Reutter stamped on one side would have been given out after Porsche bought the Reutter factory in 1963.

These fobs also came with other body builder stamps or only with the Porsche crest. As such they were not reutter specific

[haul]

Moito, Franz,

did #96 come with a lockable steering wheel, thus the FL type key,
or the non lockable ignition switch, thus the K type key?

key issue also discussed here:
http://www.early911sregistry.org/for...g-car-key-case

[moito]

Moito, Franz,

did #96 come with a lockable steering wheel, thus the FL type key,
or the non lockable ignition switch, thus the K type key?

key issue also discussed here:
http://www.early911sregistry.org/for...g-car-key-case

HI Haul
as discussed via phone today ..yes cardex shows FL key ...im not aware that any 64 came with non lockable ignition switch but i will go through my recordings when i find the time.

attached a few pix of the fobs ...all came from the same german manufacturer and out of the same old box ..note the horse with eye and much slimmer shape ...and the plain back

cu

an other question for today
what would be the correct HL reflector for `64
i do have several versions and i think #2 (non city light with cap) would be the correct one...any thoughts?

[718RSK]

Franz, non city i believe, the ones with the city provision are VW

[moito]

Franz, non city i believe, the ones with the city provision are VW

non city with cap--right?

will pm you in a short

[haul]

@franz
could you please do me the favour and post the measurements of the T bolt from the high rise grill, please?

thank you...
br
haul

[moito]

Nice Franz, did yours have the din 125 zinc plated washers under the cap nuts also? 11x5x0.6 from the top of my head. Din spec on those has since changed

nope the stainless steel are 8x4,3x0,4
the aluminum used on later versions of the grille are 8,7x4,5x0,55

[moito]

@franz
could you please do me the favour and post the measurements of the T bolt from the high rise grill, please?

thank you...
br
haul

...............

[haul]

Dear Franz,

thank you..