Well I have had this car tucked away for sometime. In 2013 I got a call that a friend of a friend knew a guy, you know one of those type of calls.
Rumor had it there was a 72 sitting away in a garage for years. Car stopped running and the owner had no money or real interest in finding out what the issue
was.
After chasing the owner down I made the trip about an hour north of Toronto to take a look. Owner didn't know what engine was in the car, or much about the car for that matter.
He was a younger guy who had bought the car 15 years earlier on a whim. After looking the car over hoping it was some mythical beast it turned out to be a non matching 72 T with a 2.7 CIS. That being said all was not lost as the chassis was near perfect and the car was complete. Sitting there covered in dust with four flats and non running the owner and I agreed on a price and the car was slowly rolled into my trailer.
Back at my garage I got to looking the car over, Cobwebs removed and washed off the car had potential to be honest the chassis was a solid as any I had seen. After a few hours I realized the issue was a simply a bad ignition switch. A bit of maintenance and it fired up. Listening to that 2.7 rumble was not too exciting as it coughed and sputtered.
From here racing season started which takes up most of my time. Believe it or not I have a full time job so this car sat in the corner for another year.
Flash forward to early 2015 and my father came to me looking to find a hotrod/outlaw. Well sitting in the corner was the car, he has deeper pockets then I.
Where the 2.7 was ok for me ,it would not due for a proper build. To be honest the chassis deserves better.
So late in 2015 I spoke to Dave Margolese at EuroTune as to ideas. I had a thought of building a period correct smaller displacement screamer. I'm all for the 3.0-3.6 builds but it wasn't for this car. After chatting with another local racer he mentioned a complete 2.4 E engine he had on the shelf. Over to his garage I went to find a very complete E with MFI. Perfect, I'll take it!
VIN 9112100449
JE Pistons where ordered with a slight over bore 2.5 10.5/1 comp
Heads were sent out for machine work and twin plug work.
Pauter Rods ordered
S Cam
and the list goes on...
I can't simply build the engine and leave the transmission, so out it comes for a fresh rebuild.
Now its winter 2015/2016
so it makes perfect sense to look over suspension upgrades, look for details on my next post.