Sound insulation in my 1969 911 E

[lrogacs]

I'm in the middle of my 1969 Porsche 911 2.0 E restoration. I try to keep the car as close to original as i can, so i don't make any updates in the car. Now i try to make the insulation on the rear parcel shelf and the rear seats. But because the insulation was almost completly missing in my car, i don't know if i did it wrong or not. Please help me with it. The only reference i had is a 10x10cm piece of felt covered with tar. I've figured it out that all the rear insulation was from this material not from this rubberised material you can see on later models.

First i had to find the correct felt. After months i found it. It is 1cm thick and looks exaclty like the reference material.



After that i had to cover the rear area with this felt. It was really hard, because i didn't have any templates for this. I saw many videos and checked a lot of photos. And i measured, then cut, and measured again, and cut again... For 2 days... But i was satisfied with thge results...



The problem was that this felt is not covered with tar (for water repellency maybe?). I've purchased some tar based "paint" and started to cover the felt.



After one layer of tar it starts to look quite good, but it needs an additional layer tomorrow to get the uniform black finish.



I know it looked way much better without tar, but what can i do if that is how it looked like originally. Now the surface of the felt is quite hard, but overall you can feel that it's some soft material. So i think it works good.

Or am i wrong? Did it look different in 1969? Please give me some advice. I have a lot of this felt material, so i can start it all over!

[edmayo]

I think you've done extremely well replicating an old style process. The only difference I can see is that if you look at an old printed parts book you can see that what was glued in were PRECUT panels with visible edges,,,,that might be the only improvement I could suggest,,,,but find parts book illustrations first to confirm what I think was done.

[lrogacs]

I think you've done extremely well replicating an old style process. The only difference I can see is that if you look at an old printed parts book you can see that what was glued in were PRECUT panels with visible edges,,,,that might be the only improvement I could suggest,,,,but find parts book illustrations first to confirm what I think was done.

I made the panels based on this picture. But i tried to hide the edges to make the surface smoother. But maybe i was too precise?

[moito]

nice work.

putting all this efford in a non visible area makes me wonder if you did not notice that there is the 73-door lock post welded on your car.i think if not corrected this would bother you every time when opening the passenger door
franz

[lrogacs]

nice work.

putting all this efford in a non visible area makes me wonder if you did not notice that there is the 73-door lock post welded on your car.i think if not corrected this would bother you every time when opening the passenger door
franz

Oh my god! I can see it now. How didn't i notice it??? I'm speechless...
It's because the chassis was restored 4 years ago, and then i were a nwebie in Porsche restoration. The only reproduction door lock post was the JP/Dansk. They suggested it from 65-89. Now i see that there are already other reproductions for 65-71 models. I will correct it before i sell the car. Danke!

[xpensivewino]

I'm at the same point in my 69 E restoration. I think your work is excellent. I've chosen a modern 3M material for my insulation, but for originality your work looks fantastic.