Results 1 to 10 of 144

Thread: MFI troubleshooting - high idle, pops and bucks at part throttle

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Serial old car rescuer Arne's Avatar
    Join Date
    Aug 2011
    Location
    Eugene, OR
    Posts
    657

    MFI and fuel troubleshooting - high idle, pops and bucks at part throttle

    Without thinking, I posted this over on the Bird site as well. Not many MFI peeps over there, except for some who are here as well. So no need to answer both places.

    Car - 1972 911T 2.4 MFI, engine all stock

    Background - Years ago (at least 3 owners ago) MFI was swapped to carbs, but parts boxed and retained. Previous owner had engine rebuilt (all stock spec) and MFI put back into service. Project stalled immediately thereafter. I bought it as a running car, but with only 2-3 hours on the engine, and no road testing (due to bad brakes).

    Now that the car is road worthy again, I'm looking at some of the basics in order to correct running problems. Main problems are high idle speed (~1300) and popping and bucking at part throttle. Smooths out and pulls nicely at wider throttle opening. These problems only surface when the engine is fully warm. When cold or during warmup neither symptom is evident.

    Keeping the old Check-Measure-Adjust doc in mind, the ignition and engine bits are good. New air filter, plugs, points, plug wires, good compression, fresh valve adjustment. Timing appears good, and the vacuum retard is working as expected.

    So I need to look at getting the idle speed down, and perhaps richen(?) the part throttle on the pump.

    So first I look at the idle. And it is my understanding that the idle is adjusted with the 6 air screws on the stacks, and then the synch is re-checked.

    But there is my first failing. No amount of changing on the air screws appears to have any effect on the idle speed. The screws were all over the place when I started, after trying to drop the idle speed for a bit with no result, I stopped the engine, screwed all of them in to the stop, then backed each out 2 full turns to have a starting baseline.

    Still idles at 1200-1300 when warm. All of them check fairly close on my synch tool, but still no idle change.

    Any thoughts?
    Last edited by Arne; 04-05-2019 at 11:46 AM.
    - Arne

    In Progress
    - 1972 911T coupe, born (and someday will be again) Silver
    Sold - 1984 911 Carrera coupe, Chiffon white; 1973 914 2.0, Saturn Yellow; 1984 944, Silver Metallic

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Message Board Disclaimer
This is a public forum. Messages posted here can be viewed by the public. The Early 911S Registry is not responsible for messages posted in its online forums, and any message will express the views of the author and not the Early 911S Registry. Use of online forums shall constitute the agreement of the user not to post anything of religious or political content, false and defamatory, inaccurate, abusive, vulgar, hateful, harassing, obscene, profane, sexually oriented, threatening, invasive of a person's privacy, or otherwise to violate the law and the further agreement of the user to be solely responsible for and hold the Early 911S Registry harmless in the event of any claim based on their message. Any viewer who finds a message objectionable should contact us immediately by email. The Early 911S Registry has the ability to remove objectionable messages and we will make every effort to do so, within a reasonable time frame, if we determine that removal is necessary.