Results 1 to 10 of 19

Thread: Restrictor fittings

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 04-13-2019, 12:41 PM #11
    Jerry L
    Jerry L is offline
    Senior Member
    Join Date
    Dec 2008
    Location
    Black Mountain, NC
    Posts
    539
    Changed back to the stock oil fittings today, measuring the stock one more accurately it is about 6.19mm and the replacement is as reported at 2.5. I have attached pics which include the Porsche P/N for the set I had, also for some who may not know what is in their motor a side view with the groove cut into the hex indicated the restrictor fitting. Also as a note while fittings were off looking at the oil line fitting the ID of the steel line that gos into the banjo fitting may be slightly smaller than the 6.1 diameter in the fitting, maybe 5.7 with a small hole gauge but very hard to get a good reading, would be interesting to cut a banjo in half to get a good measurement but no spares or old lines.
    In doing this I remembered debating about drilling them to some where between 6 & 2.5 but went with the as suggested restrictor, not any more, may drill these to 4.5 but doubt I will see any O.P. issues as I did not prior to the change.

    Best Regards
    Attached Images Attached Images   
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules


Message Board Disclaimer and Terms of Use
This is a public forum. Messages posted here can be viewed by the public. The Early 911S Registry is not responsible for messages posted in its online forums, and any message will express the views of the author and not the Early 911S Registry. Use of online forums shall constitute the agreement of the user not to post anything of religious or political content, false and defamatory, inaccurate, abusive, vulgar, hateful, harassing, obscene, profane, sexually oriented, threatening, invasive of a person's privacy, or otherwise to violate the law and the further agreement of the user to be solely responsible for and hold the Early 911S Registry harmless in the event of any claim based on their message. Any viewer who finds a message objectionable should contact us immediately by email. The Early 911S Registry has the ability to remove objectionable messages and we will make every effort to do so, within a reasonable time frame, if we determine that removal is necessary.