Hi Everyone:

I am about to replace the gaskets on my front turn signal housings and had a few questions before I started the process. Rest assured, I have the Genuine Porsche parts for the job.

1. Does the housing need to be removed from the car to install the new gaskets?
1a. If so, is the housing held on by just the 2 screws that can be seen with the lens removed?
1b. If one screw happens to snap, what are the details/sizes of the screws?
2. Does the new gasket need to be glued to the housing?
2a. If so, will standard 3M super glue do the job?

Thanks in advance!