Results 1 to 10 of 36

Thread: Connecting fog light harness to switch

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Senior Member Bob Harriman's Avatar
    Join Date
    Dec 2011
    Location
    Victorville CA
    Posts
    776

    Connecting fog light harness to switch

    I haven't been getting many responses to my TTG fog light question so I hope I can get some guidance with the switch. I purchased a Kroon fog light harness and the directions and diagram he sent with the harness calls out for the white/yellow and the white wires to be connected to the switch. White/yellow wire to the 58 and the white wire to the N but my 68 switch does not have the same terminal ID's (1,2,3 and R versus NR, N, 58 and ground) on the back at the connectors and my switch has a different connector pattern on the rear. The one in the installation diagram also does not have a bulb and has three terminals at the top and one at the bottom. The three on top have one at the top and one on each side of it at an angle. I'm assuming the ground that is supposed to connect to the lighter is for the light bulb. My car is a 69 and the switch is from a 68. Help please. Bob
    Last edited by Bob Harriman; 03-28-2015 at 03:06 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Message Board Disclaimer and Terms of Use
This is a public forum. Messages posted here can be viewed by the public. The Early 911S Registry is not responsible for messages posted in its online forums, and any message will express the views of the author and not the Early 911S Registry. Use of online forums shall constitute the agreement of the user not to post anything of religious or political content, false and defamatory, inaccurate, abusive, vulgar, hateful, harassing, obscene, profane, sexually oriented, threatening, invasive of a person's privacy, or otherwise to violate the law and the further agreement of the user to be solely responsible for and hold the Early 911S Registry harmless in the event of any claim based on their message. Any viewer who finds a message objectionable should contact us immediately by email. The Early 911S Registry has the ability to remove objectionable messages and we will make every effort to do so, within a reasonable time frame, if we determine that removal is necessary.