Wiring front Euro indicator unit, extra spade

[fourteenten]

Hi,

Anyone has picture showing the plastic plate with the wiring for a Euro front indicator unit? This one has an extra spade for parking light, white wire.
Second question, which units use a single filament bulb, see picture showing single and dual spade.

Thanks,

Cees

[fourteenten]

Back to the top, anyone?

Kind regards,

Cees

[edmayo]

Do you have the 'ghost ' light bulb? that is a small single filament bulb installed in the divider between the white lens part and the yellow.The white wire ran along the floor of the light housing just behind the lens to the ghost light. The turn signal bulb became single filament since it was ONLY used for the turn signal. The red/grey wire is marker light and the black white is turn signal. Of course if you don't have the Euro set-up forget everything I said.

[fourteenten]

Thanks Ed,

Yes I do have the ghost light with divider, it's a Euro unit but it came with the plastic rear plate w/wire so I try to make a complete Euro set. Still I think I need an extra spade to wire the ghost like and if I understand correct it would be on the red grey wire, right?

Kind regards,

Cees

[edmayo]

If I remember correctly, the female spade end of the white wire is what went to what would be the male spade of the ghost light bulb socket. The other end of the white wire had an eyelet terminal that went under the screw connection of the grey/red marker light wire.

[fourteenten]

Thanks again Ed, finally I found a picture showing the extra spade...I think I got it covered now.

Kind regards,

Cees