....
As i had the small cable fire . . .
(http://www.early911sregistry.org/for...ing-2017/page8)
I do look for a
65/66 turn signal switch
best would be NOS . . .
maybe something reliable is in your shelf
with best regards from bavaria
haul
....
As i had the small cable fire . . .
(http://www.early911sregistry.org/for...ing-2017/page8)
I do look for a
65/66 turn signal switch
best would be NOS . . .
maybe something reliable is in your shelf
with best regards from bavaria
haul
59 750 pre unit triton
63 650 gray silver bikinitub triumph thunderbird
70 650 astralred silver triumph bonneville
65 912 slate gray "erwin"
73 914 ravennagreen "ferdl", swapped 1:1 for a
10 997 racing green awd „gustl“
erwin_loves_polo
I would change the needed part with my
extreme rare
NOS SWF 644.613.301.05 turn signal switch for 356B/C/SC 60-65
59 750 pre unit triton
63 650 gray silver bikinitub triumph thunderbird
70 650 astralred silver triumph bonneville
65 912 slate gray "erwin"
73 914 ravennagreen "ferdl", swapped 1:1 for a
10 997 racing green awd „gustl“
erwin_loves_polo
Haul is that the same as for a 1965/66 912?
Dear Mathieu,
unfortunately not...as the one for 901/911/912 has a different wiring, thus a different part order number and of course a different connector than the one shown below...
as said...in exchange for a near mint or NOS 901.613.301.03, early version... the NOS 356 turn signal..
59 750 pre unit triton
63 650 gray silver bikinitub triumph thunderbird
70 650 astralred silver triumph bonneville
65 912 slate gray "erwin"
73 914 ravennagreen "ferdl", swapped 1:1 for a
10 997 racing green awd „gustl“
erwin_loves_polo
Haul, The pet is showing 69, I think that is the first year of the round connector, will look at my 68 parts this evening, main difference in mind is the 67 & earlier had a hard gloss black plactic end piece vs the pebel grain started in 68, also the stalk or lever arm was "real" metal with good plated chrome, 68 & later were inferior material and plating. will return your PM.
Best Regards
What Haul has is a "replacement" 356B/C turn signal switch. It was probably made in the 80s. Notice that it has a large rubber knob from a 68 and later switch, instead of the correct smaller black plastic one. Just replace the knob and you will have a very nice, "Old School", part and not made like the current crap from SWF.
Regards
Jim
Posting Permissions
Reply With Quote