how is the Black fuel vapour box held under the dash..?

[stretch]

Looking to fit the Black vapour box under my dash sheet metal. How is this held in position.? I see two steel clips on the scuttle metal, is there a rubber band or something to clip this on.?

Thanks in advance

Dave

[mac73s]

Here is an original 'square' rubber band which was used...loops on each of the prongs and loops under the box.

[Nicklasliljegren]

https://www.partsklassik.com/p-1589-...ing-strap.aspx

best Nick

[stretch]

Thank you Nick. Big rubber band then..

Dave

[stretch]

Thanks for the picture Mac73s.

[Nicklasliljegren]

http://www.early911sregistry.org/for...l=1#post550741

In this thread I think you should find som pics of the stock vapor box strapped in place properly

Best Nick

[stretch]

Thanks again Nick, that is really helpful. I think a Black bungee cord will do the trick nicely.

Dave

[Ivan Fuller]

or a O ring

[Dougieboy1]

Hi, what are the dimensions of the original square section band? i.e. how thick is the square section and if you were to slice band, how long would it be if you laid it flat?

Thanks

[mac73s]

Hi, what are the dimensions of the original square section band? i.e. how thick is the square section and if you were to slice band, how long would it be if you laid it flat?

Thanks

4mm square and I would say 14" if sliced and layed flat.