Name:  100_4849.jpg
Views: 450
Size:  119.6 KB
This is a pic of intermediate shaft on a 1970 2.2L engine. The central threaded/tapped portion behind the cir-clip 'floats' approx. 1/6" (2mm) back & forth.
Is there a missing bolt for this piece? If it is a missing bolt, there seems to be no surface or anything for it to react against. I could not find anything in the PET about it.
Should I be worried about this axial float or should I just clean the area & replace the gasket, bolt it back up & have a brewski?

Cheers
JB