Looking for a Source for the sliding slot bolt used on the Durant Mirror

[mfitton]

Does anyone have a source for the slotted bolt that slides on the Durant mirror?

[LiveFromNY]

I was looking a few months ago and finally ended up making one. NLA as far as I know. Someone should make them. I'd buy 20.

[mfitton]

That is kind of what I thought based on my searching.

[Jim Breazeale]

Does anyone have a source for the slotted bolt that slides on the Durant mirror?

Very easily made with a bolt and a small grinder

[mfitton]

I just thought there must be a source since most of the new repro Durant's have them.

[moito]

i do have M6 hex head with slot in vast numbers..different thread lengths..10mm head is about 3mm tall...the durant one has a shorter head and a wider slot- right?

[mfitton]

Can someone add the dimensions of the original slotted hex bolt. Thanks!

[lopena]

Can someone add the dimensions of the original slotted hex bolt. Thanks!

I’ll give this a shot:

Overall length = 24mm
Length of threads = 20mm
Width of threads = 5.75mm
Width of hex head = 10mm
Width of notch in hex head = 7mm
Depth of notch in hex head = 2.75mm
Material = galvanized steel

Good luck,
Alan
N.J.

[Bullethead]

JimmyT makes them, 11 bucks each.

https://www.early911sregistry.org/fo...nt+mirror+bolt