Recaro Bucket seat sliders

[911_2.2T]

I have one slider set to many for my Recaro bucket seats, because I was fortunate enough te be able to buy a set with uncut legs...
It cost me a kidney (figure of speach) so I'm losing the obsolete set that has the bottom sliders cut.
When I say cut I really mean that the slider bottom part is cut short, a real crude way to get rid of the legs.....
So the part is still fully functional, but it is now the same length as the top part.

For comparison I've put a slider in the picture that has cut legs, where you can see the difference in length.
So if you want to sit as low as possible in the car and put the slider on a bracket close to the floor, this is a good set for you.
Or weld it to a cross bar or afternarket adapter would also work just fine.
If you want to go for a bracket that needs the legs, you would have to weld legs on it and live with the fact that the bottom part is shorter.
Esthetically not so great, functionally that is no issue, all the locking tabs are in tact, so the slider works fine.

Would like to get $400 shipped for these.

[911_2.2T]

Reduced to $350 shipped