Message Board Disclaimer and Terms of Use
This is a public forum. Messages posted here can be viewed by the public. The Early 911S Registry is not responsible for messages posted in its online forums, and any message will express the views of the author and not the Early 911S Registry. Use of online forums shall constitute the agreement of the user not to post anything of religious or political content, false and defamatory, inaccurate, abusive, vulgar, hateful, harassing, obscene, profane, sexually oriented, threatening, invasive of a person's privacy, or otherwise to violate the law and the further agreement of the user to be solely responsible for and hold the Early 911S Registry harmless in the event of any claim based on their message. Any viewer who finds a message objectionable should contact us immediately by email. The Early 911S Registry has the ability to remove objectionable messages and we will make every effort to do so, within a reasonable time frame, if we determine that removal is necessary.
. Reproduction short wheel base 67-68 911S rear calipers for vented rotors with large 38mm pistons. Direct bolt on part for all SWB rear brakes 65-68. This was a 911S only part so originals were very rare, they allowed bolt on big rear brakes to any SWB but the rarity made them hard to find. Now you can setup big brakes on your original SWB suspension. Put the big alloy 911S/cast iron A/BremboAM calipers up front and these calipers out back with 38mm Pistons - will create a 1.6:1 bias ratio which is ideal and used by Porsche until 1984. You will need to run 67-68S rear rotors.
Reply With Quote