For those who keep track of early S models
1968 911S Chassis Number: 11801208
1968 911S Engine Number: 4080488
More information http://cgi.ebay.com/Porsche-911S-196...QQcmdZViewItem
By the way not mine
Richard
For those who keep track of early S models
1968 911S Chassis Number: 11801208
1968 911S Engine Number: 4080488
More information http://cgi.ebay.com/Porsche-911S-196...QQcmdZViewItem
By the way not mine
Richard
That's not a very good welding job on the lower right side rocker panel. Someone welded a patched inner rocker to the outer rocker.
1970 911S Coupe (Burgundrot) (sold)
1967 911 Coupe (Light Ivory) (mostly gone)
1966 911 Coupe (Sand Beige) (sold)
Van Diemen RF99 Formula Continental
Citation F1000 on the way
Van Diemen Hayabusa SCCA Formula S (sale pending)
Other Early 911/912/914
The body shop stripped the rocker back and cut the rust out for investigation purposes. The next job was to instruct them to take the rocker off and proceed could really do with the outer rocker removed and middle rocker section checked and restored before welding back up, not a major job but no time to do it, its got to go before I move...
Hence the pictures so you know what your getting.
That was the last job before hanging the doors and paint prep.
Thanks
Greg
Good to see another 68S being saved...
I was probably a bit harsh - apologies.
Having done this many times, I was disturbed at the two lower photos in the auction advertisement. They show the right side outer rocker panel over the missing portion of the inner rocker panel, with some braze welds in the more rear (aft) portion. It looked like a patch job. Those outer rockers should come off and new inner rockers welded in place before installing the outers. That's all.
It is good to see another 68S being saved. Thanks.
1970 911S Coupe (Burgundrot) (sold)
1967 911 Coupe (Light Ivory) (mostly gone)
1966 911 Coupe (Sand Beige) (sold)
Van Diemen RF99 Formula Continental
Citation F1000 on the way
Van Diemen Hayabusa SCCA Formula S (sale pending)
Other Early 911/912/914
No worries. If it doesnt sell on ebay I'm going to see the job through.
The areas were cut away, I had supplied an outer and an inner panel ready for the job, but I didnt give them the go ahead because of my move.
I'm already pencil booked to get the remaining welding done in 5 weeks time and I think Ive found a good paint man![]()
Hello, Greg.
We spoke last timeI had a bit of time to talkj!
I missed the auction..just could not get out of work.
I'm really keen and have mobilised the 10K you need.
Please let me finish her off!
I'll do it right I promise..and you can have a drive too..
Kind regards
david leopold