I've been reading and learning a lot from the forum and appreciate the knowledge and expertise shared here. Hopefully, someone can help with this issue: 1971 911T with original engine and trans. The engine hasn't run for several years and will only rotate through about 120 degrees. In an effort to get it back on the road, I pulled the engine and trans. I was able to install 2 of the bolts in the flywheel to release tension on the throwout bearing. However, the flywheel won't rotate far enough to get the 3rd bolt in. Consequently, I can't rotate the throwout bearing to release the clutch fork; and can't separate the trans from the engine.

Any ideas?

I appreciate the help!

dho