Printable View
Do any of you guys have any tricks used to install the screen washer nozzles without scratching the paint? I recently bought some repors and tried to install them tonight using soapy water but it was not going to end well so I took a tactical retreat. Any help is appreciated
Thanks
Kevin
Yes, I hate installing those. Were you both pulling from underneath while pushing from the top?
I tried. I lubed them up with soapy water but they would not hook under the metal panel. I pulled from underneath but no joy
Then start trimming some of the edge off with a razor blade. Typical aftermarket fit,,,,
Try heating them up in some very hot water
+1, but still a pain in the rear.Quote:
Originally Posted by RSTarga
You could always make the hole a bit bigger! ;)
I tried all the above and after 3 days of I finally got them installed. No fun!!!!!!!!