Printable View
came off my 914-6 (replaced with pmo's) as the idle was fluttering from worn shafts. Fine above 3300 rpm, or get them rebuilt. Excellent condition otherwise and equipped with pmo fuel bars, jetting for 3.0 or 3.2 currently, intake venturis (NO air cleaners, manifolds, or linkage- but we can source these parts new at extra cost)
$1500
no trades
PM sent.
Thanks
Andrea
I am very interested
Kind Regards
Chris
Just a little note.
I've contacted Dave after a few minutes he has started the thread via PM and Email asking for payment instructions. Also long before Andrea has posted here.
I'm just not used to reply in the thread just saying that I've send a message. The seller see this as well :rolleyes:
Nevertheless I do not know if I was first in line. I have not heard back from Dave yet.
I'm just saying that since there is some traffic here :D. This could be a good deal but if you want to work the carbs correctly I know that the rebuilt is pretty expensive :eek:.
Dave will know why he has switched for PMOs ;)
Thanks Yeti for your very correct post.
But you know, Italians Webers for an Italian guy sound good!!:D
ciao
Andrea
Ok- it looks like andrea is NOT first in line as yeti pm-ed before- see posted copy of pm log below
Apologies for the delay- busy on family all day with no computer available.
thank you
Dave
Oh Dave,
that is not quite fair. I have mailed and PM you much before I just did not post it here. I have mailed you that I take them...
Like a kid without sweets :-(
webers > log from pm messages
05:56 PM LeonardZ
07-29-2009 weber 46
09:19 AM superelfje
07-29-2009 weber 46
09:11 AM superelfje
07-29-2009 46mm webers
08:11 AM andrea70
07-29-2009 Weber 46
07:43 AM yeti
Sorry Andrea, but yeti was the first to respond. He has the right to purchase these first. You had posted at 8:09 just 26 minutes later.
Thank you all
Dave Bouzaglou
As I previously said to Yeti, if this is the situation, I accept it.
Best
Andrea
:)
Thank you very much for this great attitude!