Printable View
Hey folks... we're working on a 64' 911...hood latch panel replaced years ago with a later panel.. from what I've gathered the panel should look like what we have made for mock up purposes. Any help to confirm this is correct is greatly appreciated!
Pictures would be a bonus. Thanks in advance for any info.
Regards,
Rich
Looks correct.
John
Rich, you have a Private Message.
Hey Bob! PM sent
OK... Thanks John...it took three days and three sets of dies for the Pullmax machine..... when you cant buy it, you have to make it
Rich
Sorry- cleared out my PM box
some pics .....
on the `64 the lip for the rubber does not have the drains....
that's perfect! thank you very much....this car was hit VERY hard way back when....it at least had a Porsche replacment panel and not repop...although a few years later....
THANKS AGAIN MOITO
BTW ..is anyone making descent replacement corners at the leading edge of the inner fender? Before I make dies to stamp
hmmmm i think i have seen those corners offered recently somewhere in the net...will see if i can find them again.