Printable View
I am looking for a rubber drain tube that fits at the bottom of the blower assembly. They are NLA according to all suppliers but am hoping someone maybe has a spare or a used one in good condition. Mine is cracked and about half is missing. It is item #19 in the attached figure. Thanks.
Attachment 296610
No one with a spare or a good used one? Even if you know where else I might get one?
Possibly here...
http://www.ecstuning.com/ES1382975/
Thanks Peter. The part # is correct so hopefully it is the correct part. I'll order one and find out.
no one makes this, I have asked a couple rubber manufacturers if they would make it and they just laughed and said there is no demand.
yes .. in the end I gave up, sprayed plastic piping matt black, heated it in water to expand it, and popped it on ..!!
thats the over flow gas tube that attaches on the drivers inner fender area.
Quote:
Originally Posted by hopper
yes and that part you can buy new but not the other thingy
Was unable to locate the part so I improvised. Went to the hardware store and purchased 6" of clear plastic tubing, 1" OD and 0.75" ID for $0.75. Put the end in hot water to soften it up for about 5 minutes, sprayed the two ends with silicone and was able to slide it into place (as Paul did). Put on the spring clip and cut it to length. The 1" OD fits perfectly into the drain hole. If I ever find the correct part I can always replace the plastic tubing but at least for now the fan housing can drain as it was designed to do. Thanks to all that responded.