ITG filter set

ITG air filters. These are part no. JC40-40. New and unused. Comes with two sets of mounting plates as shown; one pair is blank - you drill/cut for your application. The other has been precut. PO says they were for a 906 engine (not verified). These will not fit regular Webers as the short height interferes with normal-height velocity stacks. $230.00

Enclosed are a couple of pics with the same size filters (not mine).

Sherwood

FWIW, add'l notes from PO:
1. In my application I was using weber 46 carbs with 906 intake manifolds. These are taller then standard ones. It is a tight fit to clear the bulkhead.

2. However with a normal set up using weber's - no problem. They can be used with MFI as well, but you have to notch for the cold start squiter. regular velocity stacks are no problem.

Hello: What is the height of the foam filter on the inside? Are you looking for any parts? Thanks Eric

Eric911s,
Sorry about the delay. I just had a chance to measure the filter.

Inside, there's 45mm of space between the al. mount plate and the plastic filter structure.

Hope this helps,

Sherwood

Hello: Sorry they are not tall enough for the air horns I'm running. Thanks Eric