SWB rear calipers for vented rotors

[91167coupe]

Anyone have a pair of Wide L rear calipers for SWB?

[gsjohnson]

http://www.early911sregistry.org/for...nted-disc-type

[91167coupe]

Thanks for the tip! I will take contact with seller, but hope to get some less expensive (if possible..)

But these look fantastic!

[Fishcop]

Pretty rare items. Contact Eric Shea at PMB, he may have something...

[gsjohnson]

Do you already have the special rotors for these?

[91167coupe]

John, I will take contact with Eric, thanks.

I do not have rotors, but have learned that SC rotors fit after some machining.

[gsjohnson]

I believe that it is the 944 rotors that they are machining and there are some short comings to this conversion.

[91167coupe]

I mean early 944 rotors of course, thanks. They are maybe not 100% but will do as they will go on an 912/6 project and not a 67S. The right rotors are expensive but cheap considered value on the calipers btw.

[preS]

I mean early 944 rotors of course, thanks. They are maybe not 100% but will do as they will go on an 912/6 project and not a 67S. The right rotors are expensive but cheap considered value on the calipers btw.

Since you are car is not a "real" S and in case you want to save a few $$, you might want to look into alternative calipers w/ a 38 mm piston.

Richard

[91167coupe]

Since you are car is not a "real" S and in case you want to save a few $$, you might want to look into alternative calipers w/ a 38 mm piston.

Richard

I am open for alternative calipers but haven't found other that fit. I have calipers (48mm?)for ventilated rotors for the front and will definetely consider anything that fit the rear SWB arms and for ventilated rotors.