Radio face plate for boogered up early dash

[CarmelSkip]

This faceplate is the way to go if your dash was cut up to install a more modern radio in an early dash. Easy way to mount the correct radio in a modified dash. $80 shipped CONUS

[StephenAcworth]

Interested: is it made by Blaupunkt to fit their radios?

[CarmelSkip]

I really don't know who manufactured it. It did come with an early blaupunkt that I bought a while back.

[mfitton]

Can you give us the measurement of the rectangle opening between
the radio shaft circles. When you say you had it on an early Blaupunkt
was it a blue dot with chrome trim around the dial?

[CarmelSkip]

I won't be able to take measurements until later in the week but if I remember correctly it came with an earlier radio not blue dot, more like a 67 radio AM FM SW or such

[yellow356]

This is a correct face plate for blaupunkt radios, I have the same. The measurements of the opening are 9 cm long and 3,6 cm wide. I'm not sure if it's for Porsche.

[Jim Breazeale]

This is a correct face plate for blaupunkt radios, I have the same. The measurements of the opening are 9 cm long and 3,6 cm wide. I'm not sure if it's for Porsche.

It isn't...................

[yellow356]

It fits blaupunkt radios for sure, but I think it's for volkswagen

[CarmelSkip]

Didn't say it was porsche specific but a clean way to deal with a boogered up dash. I also thought it might look good to paint the main section black and leave the trim ring chrome

[mfitton]

As long as the faceplate opening will take an early Blaupunkt it would be an alternative for a cut-up dash that had a modern radio in it, especially one with a wood dash.