Results 1 to 4 of 4

Thread: Body Front Section - Sheet Metal - SWB

  1. 12-03-2015, 02:51 AM #1
    Toffynose
    Toffynose is offline
    Senior Member
    Join Date
    Nov 2013
    Posts
    220

    Body Front Section - Sheet Metal - SWB

    Hi,

    Does anybody know if you can purchase repair panels for the Main body front section

    Area around the Engine number (RHD) I have seen left hand drive

    The area (bowl) around the steering tube

    The area around the Vent drain Tube brazing?

    Thanks
    Reply With Quote Reply With Quote
  2. 12-03-2015, 04:03 AM #2
    Will 1967
    Will 1967 is offline
    Senior Member
    Join Date
    Nov 2008
    Location
    Finland
    Posts
    241
    AFAIK none is available. (I would be interested as well)
    - Ville -

    1967 911 Slate Grey/red, fully restored + 66' "r-ish" hotrod project
    Reply With Quote Reply With Quote
  3. 12-03-2015, 06:13 AM #3
    chris_seven
    chris_seven is offline
    Senior Member
    Join Date
    May 2006
    Posts
    1,327
    We are slowly producing a few 'part panels' which we press on a Dual Form and we may look at making some of these section in the New Year.

    We tend to be driven by the demands of our own Workshop and as an example we have just pressed the lower half of the SWB Cross Panel.

    We have around 5 cars where this section of the panel is badly corroded but the top half is perfectly OK.

    It is much faster to just change the lower half of the panel.



    We have a NOS RHD Boot Floor Plate and we could press the RH section of this panel without too much effort.
    Reply With Quote Reply With Quote
  4. 12-03-2015, 11:50 AM #4
    Will 1967
    Will 1967 is offline
    Senior Member
    Join Date
    Nov 2008
    Location
    Finland
    Posts
    241
    Quote Originally Posted by chris_seven View Post
    We have a NOS RHD Boot Floor Plate and we could press the RH section of this panel without too much effort.
    There could be demand, e.g. I have been looking whole boot floor plate (LHD) for years, and looks like I have to patch old one.
    - Ville -

    1967 911 Slate Grey/red, fully restored + 66' "r-ish" hotrod project
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules


Message Board Disclaimer and Terms of Use
This is a public forum. Messages posted here can be viewed by the public. The Early 911S Registry is not responsible for messages posted in its online forums, and any message will express the views of the author and not the Early 911S Registry. Use of online forums shall constitute the agreement of the user not to post anything of religious or political content, false and defamatory, inaccurate, abusive, vulgar, hateful, harassing, obscene, profane, sexually oriented, threatening, invasive of a person's privacy, or otherwise to violate the law and the further agreement of the user to be solely responsible for and hold the Early 911S Registry harmless in the event of any claim based on their message. Any viewer who finds a message objectionable should contact us immediately by email. The Early 911S Registry has the ability to remove objectionable messages and we will make every effort to do so, within a reasonable time frame, if we determine that removal is necessary.