Just getting ready to spruce up/restore all of my electrical switches for my USA, late production '68 normal.

I was just going to test the switches for a closed circuit when pulled "on".

It has the rubber covered knobs. I sourced new rubber knobs from Eric Linden. I was going to get the new symbols from Stoddard or Aase as well as the little light tubes (expensive!).

The normal came with the plastic rosettes, but I was thinking of getting the chrome ones, which I think came on the L and S.

I have two sets of fog lights: one set in the bumper with yellow lenses and a TTG set. On the dash I was going to put the bumper fog switch with a yellow fog symbol in the far left position typically used for fog lights, and the TTG fog switch with a green fog symbol in the far right auxiliary heater position. The hazard light switch is in the middle.

Any thoughts or suggestions on sources or other tips for this job?