Well my 69 E coupe restoration is very near completion. I have not had the car aligned yet. I set the rear suspension using the ride height calculator that was available on Rennlist, and it worked very well. Everything in the rear suspension, is either new or completely rebuilt. The car only has test miles on it and no hard cornering speeds. My issue is this, the rear ride height differs from side to side by about 3/4 of an inch which is driving my eye nuts! The question is without having the car aligned and everything settled in the rear after some driving should I correct this imbalance now or wait until everything is completed and it's a true driver for a while? If I do need to correct it now, how much correction is needed in inner or outer splines? The rear is currently at 24" on the passanger's side, and about 24.75" on the drivers side. I want both at 24", so will rotating the drivers outer spline counterclockwise by one spline achieve the desired effect? Yes when my 180lbs is in the car it's much closer to even, but still not correct! Will rear alignment change the current side to side difference? Thanks for any advice you can give me...Steve