300090

[Bobs 67S]

To add info that Bob Joyce is pointing out in his above post>

Here is a photo of a december 1964 Passengers door post showing the two bends this panel has:

[bob joyce]

nice, clear representation bob....well done

[moito]

note that early cars did not have the two dimples(red). and the panels you get from porsche have a rounder corner than it should be.(green)

[moito]

you know that you have to get rid of this closing plate?!
and it also looks like you still have the oil line version of the RHS A-pillar

rockers have been shipped last week.

[moito]

found some more pics

[300090]

found some more pics

Thank you very much Franz!
I believe that now we have all the information to complete the inner rocker panels as well as possible.
Philippe

[300090]

Philippe ... I hope you know that the replacement quarter panels need modification...
I installed the same quarter panels on my 1968 Targa and the picture shows the modifications i made in this area...

To add info that Bob Joyce is pointing out in his above post>
Here is a photo of a december 1964 Passengers door post showing the two bends this panel has:

note that early cars did not have the two dimples(red). and the panels you get from porsche have a rounder corner than it should be.(green)

Thanks to all,
Fortunately we keep all the parts that we need to change:



Your photos and explanations help our metal guy to work with confidence.
Regards,
Philippe

PS: I'm a little surprised that the panels that Porsche, RD, Dansk, etc. sell have as many differences compared to the panels that were originally installed.

[bob joyce]

yes ... you will need to check the location of the fender support bracket near the rear of wheel opening ( also were rear bumper hangs) it may be too far forward or back... cant remember but the Dansk was different from my original 1968 location

[moito]

yes ... you will need to check the location of the fender support bracket near the rear of wheel opening ( also were rear bumper hangs) it may be too far forward or back... cant remember but the Dansk was different from my original 1968 location

right bob
all dansk/porsche q-panels i`v seen have had it welded in the wrong position..back or forth ...i do not remember eighter

[300090]

yes ... you will need to check the location of the fender support bracket near the rear of wheel opening ( also were rear bumper hangs) it may be too far forward or back... cant remember but the Dansk was different from my original 1968 location

right bob all dansk/porsche q-panels i`v seen have had it welded in the wrong position..back or forth ...i do not remember eighter

Here is a photo of the original rear fender of the 300090.
Is it this support bracket (red arrow) which is not welded in the right location on the new fenders?
Philippe