Results 1 to 2 of 2

Thread: 901 Transmission Carrier Mounting

  1. #1

    901 Transmission Carrier Mounting

    Hi all,

    When reinstalling the transmission, there are two curved shaped washers that are used on either side of the rubber bushing. When installing the ones on the bottom, convex side up or concave side up? Based on the picture from the PET catalog, it appears that is convex side up.

    Regards

    Chris
    Attached Images Attached Images  

  2. #2
    Convex side up on the bottom washers

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Message Board Disclaimer and Terms of Use
This is a public forum. Messages posted here can be viewed by the public. The Early 911S Registry is not responsible for messages posted in its online forums, and any message will express the views of the author and not the Early 911S Registry. Use of online forums shall constitute the agreement of the user not to post anything of religious or political content, false and defamatory, inaccurate, abusive, vulgar, hateful, harassing, obscene, profane, sexually oriented, threatening, invasive of a person's privacy, or otherwise to violate the law and the further agreement of the user to be solely responsible for and hold the Early 911S Registry harmless in the event of any claim based on their message. Any viewer who finds a message objectionable should contact us immediately by email. The Early 911S Registry has the ability to remove objectionable messages and we will make every effort to do so, within a reasonable time frame, if we determine that removal is necessary.