Front ali skid pan , straight bolt on in the back , bolt /screw on to the body in the front .
Light weight Ali , great to protect the plastic rs fuel tanks
$240usd plus shipping
only 4 available
Front ali skid pan , straight bolt on in the back , bolt /screw on to the body in the front .
Light weight Ali , great to protect the plastic rs fuel tanks
$240usd plus shipping
only 4 available
John Gausden
Auckland, New Zealand
(shipping carson,CA)
Early911nz.org
ST-Classic.com
ST-Classic Facebook
"Funding my obsession one nut at a time"
Do you have another shot from under the car please? Thanks!
John Gausden
Auckland, New Zealand
(shipping carson,CA)
Early911nz.org
ST-Classic.com
ST-Classic Facebook
"Funding my obsession one nut at a time"
all sold , i will look at another run in a couple of weeks
John Gausden
Auckland, New Zealand
(shipping carson,CA)
Early911nz.org
ST-Classic.com
ST-Classic Facebook
"Funding my obsession one nut at a time"
Here is a few photos of a front skid pan on a 73E Targa , these have been on for 2 years and u can see the dents / scratches taken , better then the fuel tank.
I am looking to do a new run of these starting this week , so pre order if your interested as i will only be doing 5.
John Gausden
Auckland, New Zealand
(shipping carson,CA)
Early911nz.org
ST-Classic.com
ST-Classic Facebook
"Funding my obsession one nut at a time"
Just wanted to give John a bump for anyone concerned about shipping from NZ to the states. Mine arrived in VA in great shape as advertised...Thx John....DM
John Gausden
Auckland, New Zealand
(shipping carson,CA)
Early911nz.org
ST-Classic.com
ST-Classic Facebook
"Funding my obsession one nut at a time"
One question asked , weight , these are only 1.7kgs
John Gausden
Auckland, New Zealand
(shipping carson,CA)
Early911nz.org
ST-Classic.com
ST-Classic Facebook
"Funding my obsession one nut at a time"
hi John, any way to have the front mounting done with the front suspension points? I'd like to have a guard for the 85L, but without drilling holes in the car..
911S 1973
Early 911S Registry #176
Hello, yes i have had a few questions re a solution , the only pre drilled holes available are the drain hole for the front trunk ( red arrow ) , so i am looking at making a bracket that holds the skid guard lip spreading the load and bolting through the drain hole with a double sided bonding rubber strip .
John Gausden
Auckland, New Zealand
(shipping carson,CA)
Early911nz.org
ST-Classic.com
ST-Classic Facebook
"Funding my obsession one nut at a time"