Is this right orientation for install?

[71gold]

Guys
Gasket/seal for front hose feed .
Before I glue in place want to determine if this is correct orientation?

Thanks for assistance
Frank

[Simonjjb]

I may have done it wrong also - but I put the straight area against the support for the strut

[71gold]

Simon
I had also thought about that location ....
Let see what the experts come up with
Thanks
Frank

[71gold]

Here is photo, based on the dirt profile/shadow which looks Like a thiner profile on the right side , Think where I have it positioned think this is right location .
Wait for more comments

[TheTorch]

I believe the flat goes to the outside, as you have it more or less. Here is the driver's side, from below, before I replaced them. Pretty sure it's flat to the outside (left of pic from below).

[moito]

I believe the flat goes to the outside, as you have it more or less. Here is the driver's side, from below, before I replaced them. Pretty sure it's flat to the outside (left of pic from below).

is this a 69?

[mac73s]

I may have done it wrong also - but I put the straight area against the support for the strut

+1...pretty sure I have photos of original gaskets in place...will take a look and report back.

[tom1394racing]

Here is a photo from my '70E prior to disassembly.

[TheTorch]

is this a 69?

yes it is from my 69

I found the it only fit well with the flat in the correct position. I believe the flat goes towards the strut. Here is the passenger side from above. I am fairly certain I put the new ones in with the same orientation as the originals.

[rmakosaito]

I'm disassembling a '71 targa - here's my documentation of the right side. Not sure how helpful this is because this one doesn't have a flat side, rather it has a cutout for the strut mount.