Results 1 to 10 of 12

Thread: 2.2 with Webers running rough, oil light...What is going on with this engine?

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Member Tremelune's Avatar
    Join Date
    Jul 2017
    Location
    Los Angeles
    Posts
    68

    Angry 2.2 with Webers running rough, oil light...What is going on with this engine?

    I just purchased a 1970 911T, and about an hour into my inaugural drive, the oil light came on. I pulled over and checked the oil (engine running at temp) and it was at about 3/4 dipstick.

    Today I started it up and pressure was good. When the engine was cold, I pulled up the handbrake and the light came on. I put the handbrake down and the light went off. As the engine warmed, the light came back on. The druck press continues to register at least 10psi for every 1,000rpm, and at 5k RPM it was just over 60psi. The oil is pretty clean and green, so I assume it's PennGrade 20w50 semi-synthetic.

    The engine has a pronounced shake at maybe 2,000-2,800rpm, under load or not. It does not like low revs (I'm not sure if this is related). Above 3,000rpm, it runs well, though not without a few farts and perhaps the occasional backfire (though it's rare when warm)...It's quite farty in general, but it seems happier at higher rpm and seems to pull to redline well. The car has a set of Weber carbs (that looked clean through the stacks) and a cracked plastic airbox with some extra speed holes put in it by a previous owner.

    I'm much more familiar with a 3.2, and I'm a bit boggled by this oil light...I'm not sure where to start, and I'd really rather not pull the engine out of this car before I'm through the first tank of gas...Any insight would be appreciated! I got some video of the rough running and gauges:

    https://www.youtube.com/watch?v=6K_RAo5kmsQ

    https://www.youtube.com/watch?v=okelhShI6uo

  2. #2
    Senior Member Scott A's Avatar
    Join Date
    May 2014
    Location
    South East USA
    Posts
    911
    for my thinking, for one thing:
    the handbrake light is red....on the top of the druck gauge. (it is weird, but that is a little white image of a handbrake)

    the lower red light is for the alternator/generator....and will come on if the engine is low rpm...lower than 1000.
    in my mind...i cannot remember a light for the oil.

    and my guess, for the shake, at over 2000 is the carbs, and the synchronization.....either with non-matching fuel amount, non-matching air, and most likely non-matching linkage.

    the engine is easy to take out...but I like to get them running really well before I take them out...
    a 912 engine you can start on the ground...with no extras.
    but a 911 engine is hard to bench start, for the common man, you need electronics, oil tanks, and this and that...so for me easier in the car.
    Last edited by Scott A; 07-28-2021 at 02:38 PM.

    Current long term ownership: 63 Cab, 71 911, 74 914

  3. #3
    Senior Member bob joyce's Avatar
    Join Date
    Aug 2017
    Location
    el sobrante ca.
    Posts
    1,166
    put in new plugs ..... then stand back and smile
    and ,,,,,no it does not matter if they





























    '

  4. #4
    Serial old car rescuer Arne's Avatar
    Join Date
    Aug 2011
    Location
    Eugene, OR
    Posts
    1,961
    Yeah, that is the brake warning light. Note the icon of a handbrake handle under the light. The word "Oil - " just below the brake icon has nothing to do with the light, it goes with the words "TEMP" and "PRESS" for the 2 gauges. There is no oil warning light in your car.
    - Arne
    Current - 2018 718 Cayman, Rhodium Silver, PDK

    Sold - 1972 911T coupe, Silver Metallic; 1984 911 Carrera coupe, Chiffon white; 1973 914 2.0, Saturn Yellow; 1984 944, Silver Metallic

  5. #5
    Member Tremelune's Avatar
    Join Date
    Jul 2017
    Location
    Los Angeles
    Posts
    68
    The best outcome to this would be my own ignorance. Rough running I can figure out...low oil pressure scares me.

    I guess I should...jiggle the handbrake switch??

  6. #6
    Serial old car rescuer Arne's Avatar
    Join Date
    Aug 2011
    Location
    Eugene, OR
    Posts
    1,961
    Quote Originally Posted by Tremelune View Post
    I guess I should...jiggle the handbrake switch??
    That's my guess. Or disconnect the handbrake switch.
    - Arne
    Current - 2018 718 Cayman, Rhodium Silver, PDK

    Sold - 1972 911T coupe, Silver Metallic; 1984 911 Carrera coupe, Chiffon white; 1973 914 2.0, Saturn Yellow; 1984 944, Silver Metallic

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Message Board Disclaimer and Terms of Use
This is a public forum. Messages posted here can be viewed by the public. The Early 911S Registry is not responsible for messages posted in its online forums, and any message will express the views of the author and not the Early 911S Registry. Use of online forums shall constitute the agreement of the user not to post anything of religious or political content, false and defamatory, inaccurate, abusive, vulgar, hateful, harassing, obscene, profane, sexually oriented, threatening, invasive of a person's privacy, or otherwise to violate the law and the further agreement of the user to be solely responsible for and hold the Early 911S Registry harmless in the event of any claim based on their message. Any viewer who finds a message objectionable should contact us immediately by email. The Early 911S Registry has the ability to remove objectionable messages and we will make every effort to do so, within a reasonable time frame, if we determine that removal is necessary.