wiring diagram for euro 69T

[o2jake]

I have been looking for euro wire diagram for my 69T. The only colored one, that I have found, is on ebay sold by SMC. Does anyone sell the correct diagram? Would like a colored one.

I've read some of the posts and there seems to be 2 parts to this model year.

thanks Jake

[beh911]

SL 33 was for the 69 E and S.

I have the attached for the 69 T.

[1969911T]

Does anyone have info about the wiring connectors for the front and rear blinker assemblies? Have some dim lights and am going to start by checking the voltages at these connectors. Can eventually figure out what goes where, but maybe someone has already done this??
Thanks
Steve

[edmayo]

The bulkhead plugs to each corner are molded pin connectors, they don't come apart. The wires that go to each bulb socket are accessible by removing the back of the light housing, then just record the color code to each socket spade connection. I would start by checking the voltage at the brass terminal strip under each bulb, then work your way back from there. Usually dim lights are bad grounds, temporarily ground each housing with a jumper to the chassis and see what gets you. You can remove each corner light by unplugging the bulkhead connector and removing the light housing and wiring as a unit.

[SIMI BOB]

I have a color copy (11' X 17") of the SL 35 Schematic, same as in my Workshop Manual for '69 cars, but it has 10 fuses in the top fuse box in the trunk and 8 fuses in the bottom one. Don't think that's right. PM me with an address if u want it.
Bob B

[edmayo]

10 and 8 are correct for 69 only.

[frederik]

Another quick thing to check is to wiggle the fuses in the fuse box -- some of mine were corroded a little leading to a dim tail light.

[o2jake]

pm sent, simi bob--

I had some bulbs that were loose in the sockets and some were corroded in. Took some patience to clean out.

[SIMI BOB]

o2jake, it's in the mail, no charge.
Bob B

[o2jake]

thanks Bob