Need Cylinders and Pistons for Porsche 911T 2.0 1969

[Manudfr911]

Hello everybody
I am currently rebuilding a 911T 2.0 1969 engine, I am looking for a full set of cylinders and pistons, for an original rebuild with an 8,6/1 compression ratio
Ideally, I am looking for a set that do NOT need additional machining work and a ready-to-install condition for my mechanic in France.
Anybody have these parts on his shelves somewhere or know where I can find them?
Thanks a lot, hope you guys are my savers cause I ve been looking all over

Emmanuel

[preS]

You can not receive PM’s yet (need 10 posts) but I have a set of 6x Mahle with new Wossner pistons (supposedly 9.3:1) ready to be installed in the Netherlands

I also have an used set but those used ones are often not longer within factory spec

Richard

[Manudfr911]

Thanks a lot-I am trying to stay close to the original compression ratio of 8,6

[66S]

Wossner advertised compression ratio is 9-1 for the non-S pistons. Close enough.

[Manudfr911]

Thanks for your advise
Just so I understand correctly slightly raising the ratio to 9 will have close to no impact on the rest of the engine-no early combustion noise-no needs to change additional parts...etc...
Is this the pistons we are talking about?
https://www.design911.com/p/w-ssner-...68--130-140ps/

[72targa]

^^^^ looks like the PM (private message) function is active for you. Welcome and would love to see pictures of your project.

[66S]

Racers Edge sells Wossner for less. $975 shipped but do check out eBay item 267083656664 first.it’s a Mahle 2.0T set in excellent condition.

[Manudfr911]

Ok thanks for the help I ll check both.
I ll try to post pics as well

[Manudfr911]

^^^^ looks like the PM (private message) function is active for you. Welcome and would love to see pictures of your project.

I opened a new thread with pics, only way I could do it