Results 1 to 3 of 3

Thread: Weber question.......

  1. 10-22-2002, 07:58 PM #1
    Markus
    Markus is offline
    Junior Member
    Join Date
    Oct 2002
    Posts
    9

    Weber question.......

    Is it possible for Weber carbs to be bench tested, sync'd and dialed in.

    And then put on the engine and have them working perfectly?

    Or is the only way to sync them, is on the engine?

    Thanks!!

    Regards,

    -Markus
    Reply With Quote Reply With Quote
  2. 10-23-2002, 12:14 AM #2
    philjohnson
    philjohnson is offline
    Junior Member philjohnson's Avatar
    Join Date
    Oct 2002
    Posts
    12
    I'd say that you'd have to do it with them on the engine. I understand you can get them roughly right by doing a kind of pre-install routine . . . this would get it running.

    Perhaps someone more experience could tell you where to look for this pre-install routine, or contridict me completely.

    Phil
    Reply With Quote Reply With Quote
  3. 10-25-2002, 08:36 AM #3
    roblav
    roblav is offline
    Senior Member
    Join Date
    Oct 2002
    Location
    Suffolk, VA
    Posts
    380

    Webers

    You should get them as close as possib;e on the bench. Final adjustment WILL require them to be on the running engine.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Weber 40 IDS question
    By 68S_SK2 in forum Technical Info
    Replies: 15
    Last Post: 09-24-2017, 08:01 AM
  2. CIS to Weber conversion question...
    By joeblow in forum Technical Info
    Replies: 2
    Last Post: 08-04-2010, 02:42 PM
  3. Help! - Weber question
    By gilbert911 in forum General Info
    Replies: 9
    Last Post: 12-06-2006, 02:25 AM
  4. Weber Question 40 IDA v. 40 IDS
    By t6dpilot in forum Technical Info
    Replies: 3
    Last Post: 11-21-2006, 12:55 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules


Message Board Disclaimer and Terms of Use
This is a public forum. Messages posted here can be viewed by the public. The Early 911S Registry is not responsible for messages posted in its online forums, and any message will express the views of the author and not the Early 911S Registry. Use of online forums shall constitute the agreement of the user not to post anything of religious or political content, false and defamatory, inaccurate, abusive, vulgar, hateful, harassing, obscene, profane, sexually oriented, threatening, invasive of a person's privacy, or otherwise to violate the law and the further agreement of the user to be solely responsible for and hold the Early 911S Registry harmless in the event of any claim based on their message. Any viewer who finds a message objectionable should contact us immediately by email. The Early 911S Registry has the ability to remove objectionable messages and we will make every effort to do so, within a reasonable time frame, if we determine that removal is necessary.