Turn Signal Housing Differences Euro/N.A.

[bobmagyar]

I was to begin assembling my turn signal housings yesterday after having a batch of parts plated and coated when I realized I have lost my photos of what configuration my turn signal housings had. Front and rear.

Does anyone have picture of Euro turn signal housings without the lenses on? And even more ideally with the back covers off as well?

I have both EURO and N.A. housings, wiring harnesses and parts all in a box and can't deduce what goes with what.

Thanks in advance.

Bob

[911s911rs]

Hi,

I can snap pics tomorrow of both if they haven't been posted before then.

Also, I have US front signal housing and lenses and need Euro housing and lenses - any interest in doing a trade?

Send me a PM if so...

Tim

[nick-moss]

[bobmagyar]

Thanks Nick,

So there is no bulb in the location closest to the wheel?
There is only a reflector in that location?

Or in other words a front Euro signal housing there are only 2 bulbs. One for the clear area by the horn gril and then one bulb for the rest of the orange area?

I have one signal housing casing that the hose closest to the wheel arch is not even machined out. I assume it is a Euro. However yours is bored out.

Any pictures of the rear?

Thanks again.

[nick-moss]

There is not even a bulb hole in a euro housing. There is a clear palstic "reflector" clipped in at the rear

[bobmagyar]

Thanks Nick,

The second housing pic you posted does not have the reflector near the horn grill. I assume that housing is for a specific country.

Do you happen to have any rear housings you could show?

Thanks,

Bob

[nick-moss]

Hi Bob

The second housing above is USA spec and doesn't have the sidelight addition.

These are USA units again





This is a prototype of some new housings that I am having made up in ABS