Weber & PMO parts, gauges, etc.

[cosley]

Here is a list of stuff. All the jet sizes have been confirmed. Shipping is extra and based on zip. Paypal, cashiers check or m.o.'s.
46 venturies, 36, 40, 42. 6ea. 1 set ea. $70 p/set
40/46 2 new short throttle shafts, nla $25.00 ea.
40/46 used idle screws & springs, screws are straight $15.00 all 5
40/46 6 main jets, new 140,150,160, used 170,190, $20.00 p/set
40/46 6 air correction jets, used 160, 1 set $20.00
40/46 floats, 2 new $24.00 ea.
40/46 6 .050 pump jets, 1 set $32.00
46 1 new throttle plate $11.00
40/46 2 new accelerator pump diaphram kit, 2 carb p/sets $7.00 ea.set
40/46 new accelerator pump rod, universal 1 ea. $20.00
40/46 F24 emulsion tubes, 6 ea. used 1 set $30.00
40/46 PMO fuel rails w/barb fittings both ends 1 pr. $60.00
jet gauge 0.45-1.50 1 ea. $22.00
jet gauge 1.50-3.00 1 ea. $22.00
float bowl gauge w/shims, 2 sets $22.00 ea.
T fitting w/pressure gauge 1 ea. $25.00

[cosley]

jet reamer 1 ea. $22.00

Harold #334/RG #176

[execmalibu]

how much for all 3?

[rick2]

I'd like these;
40/46 PMO fuel rails w/barb fittings both ends 1 pr. $60.00
and these if they aren't already taken,
jet gauge 0.45-1.50 1 ea. $22.00
jet gauge 1.50-3.00 1 ea. $22.00
Shipping would be to, 34787 Winter Garden, Florida
Thank you!
Rick

[cosley]

Sales pending
Ernie W 2 jet gauges, 2 float bowl kits
Rich2 PMO fuel rails
Will pm with shipping costs.
thanks,
H.

[jaudette3]

T-fitting with pressure gauge - $25.00

Thanks,
John

[CamBiscuit]

Harold

I'd like
- 140 main jets
- 160 air correctors

Shipping to 0820 Australia. Is paypal OK for you? Will send pm.

Cheers

Cam

[Matt Blast]

I will buy:

idle screws and springs $15
six 0.050 pump jets $32

Are the short throttle shafts the 8.0mm or the later version 8.5mm?
If they are 8.0mm I take them too at @ $25 each

Groton, MA 01450

Thanks, Matt

[cosley]

Matt,
The shafts are 8mm. I think the pump jets are a little longer than the originals (Pierce Manifold said they were direct replacements since the originals are nla. Receipt part # 76202.040) They were originally .040 and I had them drilled out to .050. Do you still want them.
thanks,
Harold

[Matt Blast]

OK then I'll pass on the pump jets but I'm interested in the shafts and idle screws/springs.

Thanks, Matt