Photos please! Engine electrical panel on '67S

[Sacto S]

I have attempted to find some photos via the "search" and struck out. I'd appreciate any photos you good folks could post showing the electrical service panle area of the engine compartment.

I am piecing my project back together and this is one area where my "drawings" and memory both lack the level of detail necessary.
Thank you!

[68S_SK2]

Here 2 pictures taken out of the web from a 67S, which seems original for me besides the Bendix fuel pump sticker.
The ballast resistor 901 602 85 200 is a Beru type. Most European cars had the Bosch resistor, which looks different.
I hope it helps.

Claudius

[John Fusco]

John Cramer started a thread on this a few years back - might have been over on Pelican.

Can't remember the title - ultimate thread on SWB [something ]
If you do a search for threads started by JC you should find it - just set aside a chunk of time and be prepared to take a few detours- he started an awful lot of good SWB threads.

[Fidalgo911]

Here 2 pictures taken out of the web from a 67S, which seems original for me besides the Bendix fuel pump sticker.
The ballast resistor 901 602 85 200 is a Beru type. Most European cars had the Bosch resistor, which looks different.
I hope it helps.

Claudius

Claudius, actually that picture is from a '65 911 I used to own. However, I don't imagine it's much different than a '67. You are correct about the fuel pump, it wasn't original hence the brass fittings to house the metric banjo fittings.

John's thread on early electrics: http://forums.pelicanparts.com/showthread.php?t=252299

[Sacto S]

The photos and Pelicna links were just what I needed!

[304065]

Ahh yes. . . "Before there was BHKZ. . . " this Cramer fellow, he must be OCD. . .