Results 1 to 10 of 10

Thread: 911R window details?

  1. 10-20-2008, 02:49 PM #1
    TRE Cup
    TRE Cup is offline
    Senior Member
    Join Date
    Aug 2003
    Location
    Van Nuys, Ca
    Posts
    1,025

    911R window details?

    Hi everyone
    we are assisting another shop that is restoring a real R and looking to get some details on the windows. Already searched and found Ernie W.'s post on the rear quarter window that had a stamping in the plexi (Restartglas etc etc)
    Looking for detailed shots of this and other windows on the cars that show a stamping in the plexi

    fwiw- we will have VERY correct replica window sets availble in the very near future. Even the aged yellow will be available. The back window was produced with a reverse flange to allow a near flush fit with the rear chassis frame. They were glued in of course. This will also be available

    Thanks for the help!
    Dave Bouzaglou
    Member #755
    Conda Green 70 911S
    70 black 914-6 3.2
    70 911 "Speedster" project
    "74 IROC" tribute Jade Green RSR
    Reply With Quote Reply With Quote
  2. 10-20-2008, 04:05 PM #2
    TRE Cup
    TRE Cup is offline
    Senior Member
    Join Date
    Aug 2003
    Location
    Van Nuys, Ca
    Posts
    1,025
    If the windows have imprint stamps, then if we can borrow them to get the imprint correct, that would be wonderful (totally non destructive of course!)

    if they don't have imprints then that is ok- pics would do perfectly to compare to

    Awesome!! thank you for helping
    Member #755
    Conda Green 70 911S
    70 black 914-6 3.2
    70 911 "Speedster" project
    "74 IROC" tribute Jade Green RSR
    Reply With Quote Reply With Quote
  3. 10-20-2008, 06:32 PM #3
    Chuck Miller
    Chuck Miller is offline
    Moderator Chuck Miller's Avatar
    Join Date
    Oct 2002
    Location
    Reseda, CA.
    Posts
    12,460
    Dave,
    You probably have it, but if you don't, this might be of interest until Raj gets back to you................. off Ernie's R site

    http://www.pbase.com/911r/image/25042025

    Hope this helps,
    Cheers
    Chuck Miller
    Creative Advisor/Message Board Moderator - Early 911S Registry #109
    R Gruppe #88
    TYP901 #62
    '73S cpe #1099 - Matched # 2.7/9.5 RS spec rebuild
    '67 Malibu 327 spt cpe - Period 350 Rebuild

    ’98 Chevy S-10 – Utility
    ’15 GTI – Commuter
    Reply With Quote Reply With Quote
  4. 10-21-2008, 08:23 AM #4
    TRE Cup
    TRE Cup is offline
    Senior Member
    Join Date
    Aug 2003
    Location
    Van Nuys, Ca
    Posts
    1,025
    Thank you chuck
    that was the one i found earlier Ernie had posted on this site as well.
    I don't think that all the R's had this detail either. But want to get our new product as accurate as possible

    we even found a way to yellow the plastic to give it the authentic patina
    Member #755
    Conda Green 70 911S
    70 black 914-6 3.2
    70 911 "Speedster" project
    "74 IROC" tribute Jade Green RSR
    Reply With Quote Reply With Quote
  5. 10-24-2008, 07:34 PM #5
    Ernie W
    Ernie W is offline
    Senior Member Ernie W's Avatar
    Join Date
    Jul 2003
    Posts
    505
    Dave,
    Photos of R#11, R#20, and the Prototype R (Yellow car) appear to have original factory rear side windows with NO stamp. The original left side window from R#5 does have the stamp.
    Attached Images Attached Images     
    Ernie W
    member of Early 911S Registry
    Reply With Quote Reply With Quote
  6. 10-25-2008, 08:02 AM #6
    John Straub
    John Straub is offline
    Vintageracer John Straub's Avatar
    Join Date
    Sep 2006
    Location
    La Quinta
    Posts
    3,184
    This is from my GT, I see that it is different than the 911R.

    Some of the GT's I've seen have this, some do not.

    John
    Attached Images Attached Images  
    1959 356 Coupe, 1600 Super, sold
    1960 356 Roaster, race car, SCCA, sold
    1960 356 Roadster, show car, sold.
    1962 356 Cab, show car, sold.
    1965 911 #301111, Red Book Vol 1 "Cover Car," owned 54 years.
    1967 911 #307347, bare-bones, some road wear, a little surface rust, and a few dents..., owned 14 years.
    1970 914/6GT, (Sold - ran the last three Rennsports)owned 30 years.


    Photography Site: JohnStraubImageWorks.com

    Registry #983
    R Gruppe #741
    Reply With Quote Reply With Quote
  7. 10-25-2008, 07:07 PM #7
    Ernie W
    Ernie W is offline
    Senior Member Ernie W's Avatar
    Join Date
    Jul 2003
    Posts
    505
    356A, plastic window stamp.
    Attached Images Attached Images  
    Ernie W
    member of Early 911S Registry
    Reply With Quote Reply With Quote
  8. 10-26-2008, 05:04 AM #8
    OliveR
    OliveR is offline
    Senior Member
    Join Date
    Jul 2004
    Posts
    2,122
    Pics from 11899002,no stamps
    Attached Images Attached Images   
    Reply With Quote Reply With Quote
  9. 10-29-2008, 01:19 PM #9
    TRE Cup
    TRE Cup is offline
    Senior Member
    Join Date
    Aug 2003
    Location
    Van Nuys, Ca
    Posts
    1,025
    i am soo confused !!!

    thanks guys- easier to make them without and kinda confirms my prior history on real R's that I have seen close up
    Member #755
    Conda Green 70 911S
    70 black 914-6 3.2
    70 911 "Speedster" project
    "74 IROC" tribute Jade Green RSR
    Reply With Quote Reply With Quote
  10. 03-18-2009, 02:22 PM #10
    TRE Cup
    TRE Cup is offline
    Senior Member
    Join Date
    Aug 2003
    Location
    Van Nuys, Ca
    Posts
    1,025
    any close ups of the flanged back window?
    thanks again
    dave
    Member #755
    Conda Green 70 911S
    70 black 914-6 3.2
    70 911 "Speedster" project
    "74 IROC" tribute Jade Green RSR
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. FS: Chrome Plated Brass Vent Window Frames w/ vent window glass + NOS window parts
    By s2guy in forum For Sale: 911 Parts
    Replies: 4
    Last Post: 10-09-2011, 02:09 PM
  2. Details Details! Which Speaker Grille Is Correct For A 1969-1973?
    By execmalibu in forum For Sale: 911 Parts
    Replies: 33
    Last Post: 06-22-2008, 06:54 AM
  3. FS: 911R style vent window
    By JBQuick in forum For Sale: 911 Parts
    Replies: 0
    Last Post: 11-25-2007, 01:25 PM
  4. Lights and hood, the details, the details..........
    By Zithlord in forum Technical Info
    Replies: 1
    Last Post: 08-22-2006, 02:17 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules


Message Board Disclaimer and Terms of Use
This is a public forum. Messages posted here can be viewed by the public. The Early 911S Registry is not responsible for messages posted in its online forums, and any message will express the views of the author and not the Early 911S Registry. Use of online forums shall constitute the agreement of the user not to post anything of religious or political content, false and defamatory, inaccurate, abusive, vulgar, hateful, harassing, obscene, profane, sexually oriented, threatening, invasive of a person's privacy, or otherwise to violate the law and the further agreement of the user to be solely responsible for and hold the Early 911S Registry harmless in the event of any claim based on their message. Any viewer who finds a message objectionable should contact us immediately by email. The Early 911S Registry has the ability to remove objectionable messages and we will make every effort to do so, within a reasonable time frame, if we determine that removal is necessary.