Wtb nos / new rear slam panel / cross member

[advtracing]

Wtb nos / new rear slam panel / cross member as ringed in red in the photo.
I have a good s/hand one but i would like a new one with both the inner and outer panel and can't seem to find a supplier

[Will 1967]

I bought new one directly from Porsche, they are available at very reasonable cost.

[210bhp]

John
I have a NOS one which I could send you pics of if you like. It is a post 73 type with the little bulge in the pressing on the lhs. I don't know if this fits in with your plans but a 'correct' pre 73 NOS one without the bulge may be hard to source. Not sure of shipping costs either. Would need to look into that for you.
EDIT Just reread your post and realise it is only the outer panel I have.(the one where the stickers go)
Regards
Mike

[advtracing]

Thnaks for the offer , why is there not both the inner and outer availible? makes you wonder

[Will 1967]

Thnaks for the offer , why is there not both the inner and outer availible? makes you wonder

As I said, whole panel (inc engine mounts) is available new from Porsche.

[advtracing]

prior to posting i chased the OPC in new zealand , they said not availible ,
I contacted my other supplier FVD and they advised outer panel only .
Restoration design doesn,t answer emails but shows outer only .
Auto atlanta never replies to emails , and i have left another email with stoddards .

So if porsche GB has them i'll chase them

[Will 1967]

I bought it from Mittelmotor (Germany) specifying original panel is needed. Worth checking them as (at least inside Europe) their shipping is pretty cheap, hpefully it'd still be available.
Good luck for search!

[advtracing]

I bought it from Mittelmotor (Germany) specifying original panel is needed. Worth checking them as (at least inside Europe) their shipping is pretty cheap, hpefully it'd still be available.
Good luck for search!

went to porsche ag direct and found what you advised ( thanks ) so have blasted OPC nz and ordered the part