WTB: '73 rear seatbelt covers

[Varooom]

Winding down a full resto on a '73 S coupe and I need the passenger side seatbelt cover(hard plastic covered in vinyl). I have an original drivers side.

I will take just the plastic if thats all you may have. Not perfect or cracked good too. A deal on both sides is OK also.

Any leads will be greatly apprieciated!!




-

[denson]

If you cannot locate one, Tony at Autobahn Interiors will make you a perfect one. His work is exceptional.

[teenchy]

I have a matching pair from a '72 coupe identical to the one shown. I picked them up to use in my '70 to cover the inertia reels I installed. Then I realized that the vinyl pattern isn't the same and I don't think the reels were covered in '70s, anyway. (Someone please correct me on this: were the covers used on '70-71 cars, with the smooth vinyl pattern?)

I also have the interior panels with holes precut for the reels from the same '72 coupe; I intended to use them while keeping my original interior panels and repa non-reel belts for a future owner, should they decide to revert.

I'm not a stickler for originality but I wanted my install to have as close to a factory look as I could. Subsequently I picked up a pair of interior panels from a parted-out '71 coupe and cut them to accommodate the reels.

Long story short: If these are correct for '70 I'll get them recovered in '70 vinyl. If not, then I'm open to offers (and I'll get you some pics).

Sorry to be so long-winded.

Ed