F/S Assorted 911 engine parts

[Thorshammer]

Hi,


I have many things for sale after many years building 911/914-6 engines.

Turbo valve covers, 3 prs 1 blk, 2 prs in natural condition. 1 pr polished upper covers that have been clear coated. 45.00 each for the turbo covers, 25.00 for the polished covers

8/68 2.0 cylinder head with valves, springs, retainers. These are in very good condition. There are two broken fins on two of the heads, these would make exccelent race application heads for porting. They are glass beaded and clean, ready for porting or twin plug modifications 300.00

1 pr of timing chains with less than 30 mins run time 30.00

2.7 S engine Fan Shroud with oil cooler duct 75.00

Oil return tubes with viton seals 25.00

2.7 liter case with small flaw in the outer lip of the main seal area, this was repaired with JB weld by the former owner, but I never used the case, the bearing saddles are in good condition 150.00

2.0 Race engine longblock with manifolds (it is listed here) 7,000

Race Prepped 40mm Webers with over 40 hours of race prep
-Tall venturis
-PMO -6 fuel blocks
-Float bowl anti slosh mod
-ITG air filters and housings
-Thinned throttle shafts
-38mm Venturis
-Linkage
-No Manifolds 2200.00

Electromotive HPV1 Single plug ignition system complete 650.00

914-6 Exhaust system 6into 2 into 1 partial stainless steel 1500.00

914 side shift trans (no lsd) with all linkage 250.00

Thanks for looking,



Erik Madsen 508-524-3145 or soccerrace@aol.com