FS: Used ST Mahle long stroke P/C Set

[Matt Blast]

A still usable set of Mahle 86.7mm Pistons/Cylinders with pins assembled and ready to install. Cylinders have been replated. Rings are new from Andial. See specs. Asking $1800

Cyl diam 86.73mm
Pistons diam 86.62mm

Pistons with pins Wt. (gms)
1>496 2>494 3>496 4>496 5>496 6>497

ring lands
1> .004" 2> .006 3> .004 4> .004 5> .005 6> .005

ring gap None greater than .016" (all .013-.016)

Pictures have shadows. I can retake if you need to see more.

Thanks,

Matt

[letsrollbabe]

pm sent.

Gib

[manu72S]

hello

Is there a reference numbers inside the pistons and cylinders ?

Thanks

[martini911]

I'm online
Pm me please
Philippe

[Matt Blast]

The cylinders say MAHLE E on one side and on the other they have 85ZN2A!+W1. The cylinder are also numbered 1 to 6

The tops of the pistons have 86.65 stamped in the tops (very small). The piston tops also have a capital E stamped into them with some very tiny numbers stamped next to or around the E. The tops also have a more prominent number or two stamped in to them. I can try to shoot pictures if you like.

I have been asked if these were plated for cosmetics so to clarify....These were sent to US Chrome in Wisconsin to have the bores re-Nikasil plated and refinished. The pistons and the outsides of the cylinders are cleaned but have their natural finish.

Matt

[Matt Blast]

I found another number. Underneath the dome of the pistons there is: 84P84 and then W2 under that code. Also there is another marking near those but I can't see it very well with the wrist pin blocking my view. Hope this is helpful.

Matt

[Matt Blast]

These have been sold.

Thanks,

Matt

[Longballa]

Hey all, I own these pistons and cylinders now and I have them for sale. I'm going a different direction with my new motor. $1800.00 OBO. Thanks, -Scott

[advtracing]

damn, bad timing for me , could use these

[Longballa]

911r67, your PM box is full. I sent you a pm but you need to clear some space.