Parting '68 912

[endo911rs]

Not much left...basically a rolling chassis.

I need sheet metal from the rear quarters but most of the rest of the car is up for grabs. The front pan has some rust and has been previously repaired at some point. Floors have also been replaced but I think Stevie Wonder welded the new ones in. The rest of the car is really pretty solid. The front latch panel is good...let me know what you are looking for and I'll price it based on the difficulty to cut and ship.

All of the suspension is still there and the brakes. It has a front sway bar...again, let me know what you are looking for, be realistic about shipping.

Some gauges...speedo and fuel/oil level. $25 ea

901 shifter, shift tube $75...chrome is pretty good

Hand brake assembly $50...needs cosmetic resto but functional

[mshaver51]

i need rust-free lower inner fender on both sides. from nose panel, below below the bumper receiver, back to the suspension mounts. your photos don't really show the condition of yours.

thank you.

ms

[911 SWTARGA]

Hi,
is speedo in miles or kilometers?
If kilometers I will take it.
Thanks
John

[68911+1]

Interested in center dash panel for radio. Photo of condition would be great.
Thanks

[johnc]

I need the hacked piece in the photo, top section of passenger well912 inside 001.jpg,about 12 inches square, thanks, John

[oscillon]

Could I purchase the drain tube and the support brace for the cowl?

[classic]

PM sent on the front sway bar and all the hardware, to check on the postage to Australia 4224

TIA

[merbesfield]

If Classic does not take it, I could use the actual sway bar itself. Don't need the hardware, just the bar that runs through the body. Thx

[preS]

Mark I don't know whether it's of importance to you but the 912 might be smaller in diameter (13) than 911 (15).

Richard

[john1180]

Chris, interested in the gauges, sent you an email today. John