FS: SWB Fender & Rear Decklid for Hershey Delivery

[mshaver51]

Neither of these pieces is perfect, but the flaws are clearly visible so there should be no surprises.

I have a nice SWB rear decklid for Hershey delivery. The decklid was media-blasted and primed with self-etching primer. There are two small areas of bondo along the lower edge. The center post is stamped with either "11" or "77". I'm asking $450 for the decklid, but if the price is improper, I am prepared to be educated.

In addition, I have a passenger side '68 fender, which was also media-blasted to expose flaws. I was planning on using this fender for my project, but I found an NOS fender, instead. The fender is bondo-free, but as the photos show, the tail piece and the signal bucket had some rust. The underside of the fender has been painted with silver POR15, so it is ready for undercoating after the steel is correct. The fender was etched (with zinc phosphate, I believe), and the outside has not been further treated. I'm asking $550 for the fender, but as above, I am willing to be educated if this is out of line.

[mshaver51]

I hope the photos tell the story.

[mshaver51]

bump to top